Experiment set ELECTRICS 7

Not a modular system
The circuit elements in this experiment set are not assembled together according to a stiff combination mode. Instead they can be arranged in any layout on the 35 x 27 cm circuit grid board and connected together with leads. This allows students sufficient scope for putting a circuit together from a circuit diagram in whichever way they want.
Component modules are open at the bottom
The circuit elements are made of unbreakable plastic carrying rugged electronic components. They are open at the bottom so that the components, their wiring and the quality soldering can all be seen clearly. The highly flexible leads with their high-quality safety plugs not only provide excellent contact but can be used along with the circuit grid board to make even the most complex circuits lucid.
No need at all to plug in
The components of this experiment set are designed in such a way that all the experiments can be carried out with the help of the battery holder with its three AA batteries. Firstly, this ensures safe protection against overloading and also eliminates the need to plug into the mains
01.01.10 Storage box
08.02.50 Inlay with cut-outs for E7
08.03.50 Base plate E7
06.04.00 Battery holder with 3 AA batteries (2 pieces)
08.05.00 Coupling E7 (4 pieces)
08.06.50 Element light bulb E7 (2 pieces)
08.07.50 Element switch (2 pieces)
08.08.50 Element potentiometer
08.09.50 Element transistor E7 (2 pieces)
08.10.50 Element LDR (light-dependent resistor)
08.11.50 Element resistor 100 Ω
08.12.50 Element operational amplifier
08.13.50 Element red LED
08.14.50 Element capacitor (2 pieces)
08.15.00 Short-circuit plug E7 (2 pieces)
08.16.30 Element Si-diode
08.16.50 Element Ge-diode
08.16.70 Element Z-diode
08.18.00 Experimentation cable 8.5 cm (2 pieces)
08.19.00 Experimentation cable 17 cm (2 pieces)
08.20.00 Experimentation cable 34 cm blue (4 pieces)
08.21.50 Element buzzer
08.22.50 Element loudspeaker
08.23.50 Element microphone
08.24.50 Element resistor 1 kΩ (2 pieces)
08.25.50 Element resistor 5 kΩ (2 pieces)
08.26.50 Element resistor 10 kΩ (2 pieces)
08.27.00 Short-circuit jumper (4 pieces)
08.28.00 Ruler
Additionally required:
00.07.10 Multimeter AMM 3000 (2 pieces required)
E7-1: Potentiometer circuits
E7-2: Light-dependent resistors (LDRs)
E7-3: Characteristics of germanium and silicon diodes
E7-4: “Magic” circuits using diodes
E7-5: Light-emitting diodes (LEDs)
E7-6: Zener diodes
E7-7: UBE-IC characteristic (base-emitter voltage to collector current) of a transistor
E7-8: Use of transistors for switching
E7-9: Base-collector current characteristic
of a transistor
E7-10: Use of transistors for amplification
E7-11: Touch switches
E7-12: Voltage across a capacitor
E7-13: Multivibrators
E7-14: Voltage characteristic of an operational amplifier (op-amp) E7-15: Amplification of small currents


